Cooper Lumiere Boca 696 Instrucciones De Instalación página 7

Aiming and Accessories
9. Aim LED Module
3/16 Hex Head
Figure 15.
Trim Ring Installation
11. Install Glass/Trim Ring
N otee: Ensure All Mounting
Holes and Sealing
Surfaces are Clear of
Debris Before Installing
Gasket/Glass
Figure 17.
Adjust By Hand Only
!
No Power Tools
Position Locking Screw
25° Max. Tilt
9/64" Hex Head with
silicone o-ring (4x). (Do Not
Overtighten 10 in-lbs max).
Trim Ring
Glass
Gasket
Bucket
Ensure Lamp Housing
is Seated Properly
Before Installing
Gasket/Glass
Installation Instructions - Boca 696
IL509001ML
Installation Instructions – Boca 696
10. Accessory Lens Location
Snap Ring
Accessory lens location. Max. of
three (3) lens accessories only with
snap ring
Cross section of lamp housing showing
accesory lens location.
Figure 16.
12. Screw Install Sequence
Tighten Trim Ring by Following Numbered Sequence in Two
Passes. Tighten Screws to 10 In-Lbs.
3
To Remove Condensation From Fixture, Turn ON
N otee:
For 10-15 Minutes Before Securing Lens and Trim
Ring.
Figure 18.
www.cooperlighting.com
1
4
2
7