Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions – Boca 696
Lamp Information
N
otee:
Make sure fixture is cool to touch prior to
servicing.
N
otee:
Use only lumiere supplied 12V, MR16 Bi-pin style
LED module or approved lamp by factory, 13 watts
maximum. Check package carefully for proper lamp
type and wattage.
To Lamp Fixturee:
1.
Remove lens bezel by loosening the four screws and
lifting out lens bezel. (Figure 19.)
2.
If already lamped, remove the two 4-40 screws
and pull out module. Do not twist. Remove LED
module from box and remove the nuts from the
4-40 screws. The nuts are only used for shipping
purposes. Install new LED module making sure the
LED Bi-pins are aligned with socket. Do not turn.
Install two 4-40 screws making sure heat sink on the
LED module makes full contact onto fixture base.
3.
Replace lens bezel and tighten screws.
To Aim Lampe:
1.
Remove lens bezel by loosening the four screws and
lifting out lens bezel.
2.
To Adjust Vertical Tilt Aim: Use Phillips head
screwdriver to turn adjustment mechanism at base
of socket assembly. Rotating screwdriver will raise
or lower the aim until lamp is in the desired tilt
position.
3.
To Adjust Horizontal Aim: Loosen inner housing
locking screw. Rotate inner housing until lamp is
pointed in the desired direction, then tighten locking
screw.
4.
Replace lens bezel and tighten screws
Lumiere LED Module
High Mode (10W) Switch to Left
Low Mode (6W) Switch to right
HI
Figure 19.
8
# 4-40
Screws
LO
Installation Instructions - Boca 696
IL509001ML
www.cooperlighting.com
Publicidad
Tabla de contenido
