Fisher-Price Power Wheels H4804 Manual Del Usuario página 12

Ocultar thumbs Ver también para Power Wheels H4804:
Tabla de contenido

Publicidad

F
e Key Assembly
f Bloc clé
S Unidad de llave
e Dash
f Tableau de bord
S Tablero
3
e • Insert and "snap" the key assembly
into the opening in the dash, as shown.
f • Emboîter le bloc clé dans le trou du
tableau de bord comme illustré.
S • Introducir y ajustar la unidad de la
llave en el orificio en el tablero,
como se muestra.
12
e ASSEMBLY f ASSEMBLAGE S MONTAJE
e Steering Column
f Colonne de direction
S Columna de mando
4
e • Wipe the steering column with a paper towel to
remove any excess lubricant.
• Turn the vehicle on its side.
• Insert the straight end of the steering column
up through the hole in the vehicle floor and
out through the hole in the dash.
• While holding the steering column in place,
turn the vehicle upright.
f • Essuyer la colonne de direction avec un essuie-
tout pour enlever le surplus de lubrifiant.
• Mettre le véhicule sur le côté.
• Insérer l'extrémité droite de la colonne de
direction dans le trou du plancher et la faire
sortir par le trou du tableau de bord.
• Tenir la colonne de direction en place et
remettre la carrosserie debout.
S • Limpiar la columna de mando con una toallita
de papel para eliminar el exceso de lubricante.
• Poner el vehículo sobre un lado.
• Introducir el extremo recto de la columna de
mando en el orificio del piso del vehículo,
saliendo por el orificio del tablero.
• Mientras sujeta la columna de mando en su
lugar, poner el vehículo en posición vertical.
e Tab UP
f Patte VERS
LE HAUT
S Lengüeta
e Hole
para ARRIBA
f Orifice
S Orificio
e Bottom View
f Vue dessous
S Vista inferior
5
e • Position the steering wheel so that the
large opening and the tab on the steering
wheel stem are both UP.
• Fit the steering wheel onto the end of
the steering column.
f • Placer le volant de façon que la grande
ouverture et la patte de la tige du volant
soient VERS LE HAUT.
• Placer le volant sur l'extrémité de la
colonne de direction.
S • Colocar el manubrio de modo que el
orificio grande y la lengüeta del manubrio
estén para ARRIBA.
• Ajustar el manubrio en el extremo de
la columna de mando.
e Steering Wheel
f Volant
S Manubrio
e Steering Column
f Colonne de direction
S Columna de mando
e Side View
f Vue du côté
S Vista lateral
e Large Opening UP
f Grande ouverture
VERS LE HAUT
S Orificio grande
para ARRIBA
H4804pr-0720

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Power wheels h4806Power wheels h9170

Tabla de contenido