Publicidad
Idiomas disponibles
Idiomas disponibles
OVEN FAILS TO OPERATE - NO HEAT
1. Check power supply.
2. Check plug at either end of the power cord. Check complete
power cord for continuity. If defective, replace the entire cord.
3. Disconnect heating element from the thermostat (under shell
top/lid assembly) and from the power inlet (inside base).
Check heating element for continuity. If no continuity, replace
heating element.
All wiring repairs should only be done by a qualified electrician .
Failure to do so may result in risk of electrical shock, serious personal injury or damage to
STANDARD
POWER INLET
ELEMENT
GROUND
PRE-SET THERMOSTAT
8711 West Port Avenue • Milwaukee, WI 53224 USA • Phone (414) 973-3400 • Fax (414) 973-3275
TROUBLESHOOTING - TYPE 1 OVENS
III.
** CAUTION **
TYPE1 WIRING DIAGRAM
www.phx-international.com • info@phx-international.com
4. Disconnect wiring from the thermostat. Check for continuity
through thermostat. If no continuity, replace thermostat.
OVEN OPERATES - OVERHEATS
1. Check power supply for proper voltage (see rating on unit).
Disconnect power before opening or servicing unit.
Make sure oven is cooled before opening or servicing
the unit.
WITH INDICATOR LIGHT
ELEMENT
** WARNING **
unit.
POWER INLET
Indicator Light
PRE-SET THERMOSTAT
N5610459B-5
Publicidad
