Jump-N-Carry JNC8550 Manual Del Usuario página 8

The Jump-N-Carry may be stored virtually anywhere, and in any position. However,
take precautions to ensure that the positive and negative clamps do not come into
contact with each other or a common metal surface. We recommend storing the
Jump-N-Carry in the box in which it was originally received. Always be sure to re-wrap
cables and re-holster clamps after each use and prior to storage.
Battery Replacement and Disposal
This unit contains a lithium battery. This battery must be
recycled. Consult your state or local government concerning
regulations for proper disposal.
The internal reserve capacity battery inside this product is a lithium battery. It is required
by law to be removed and recycled or disposed of properly. While there are federal
regulations that must be complied with throughout the United States, your individual
state or local governments may have additional regulations to be followed.
When the battery in this product is in need of replacement, remove it according to the
instructions provided below and take it to your local recycling center for proper recycling
or disposal. If you don't have a local recycling center that handles lithium batteries,
contact your local environmental agency for instructions.
Removal instructions:
Begin by making sure that both clamps are securely placed in a position that ensures
they will not come into contact with each other.
1. L ay the Jump-N-Carry down on its front. On the back of the unit, locate the 15
screws that hold the case together.
2. Remove the screws, then lift off the back half of the case, lifting first from the
bottom.
3. The internal reserve power lithium battery is mounted n the top of the ultracapacitor
box. First, remove the lithium battery from the power circuit by disconnecting its
quick attach harnesses (2 connections to separate).
4. T hen, remove the two screws used to mount the lithium battery to the top of the
ultracapacitor box and reserve the screws for step 5.
5. Install replacement lithium batter onto top of ultracapacitor box using the two
screws removed in step 4.
6. Reconnect the power connections using the quick connect harnesses that were
disconnected in step 3.
7. Reassemble case using the 15 previously removed screws.
Storage
8