NOTE
►
The next time you switch on the device, the remote
release 8 will connect automatically to the last-connected
smartphone. If your smartphone does not automatically
connect to the remote release 8, you must establish the
connection manually. You can find a detailed description
of how to do this in the operating instructions for your
smartphone.
►
If you want to connect another smartphone to the remote
release 8, press and hold the
2 seconds. The operating LED briefly flashes blue twice
and then continues to flash every second. The remote
release 8 is now in pairing mode for about 1 minute and
can now be connected to another smartphone.
Attaching a smartphone to the selfie stick
♦
Pull the clamps of the smartphone holder 2 open.
♦
Place the smartphone between the clamps of the smart-
phone holder 2 by pushing the upper clamp upwards
against the spring force. Check that your smartphone is
securely in place.
♦
Loosen the locking screw 3 and adjust the vertical tilt angle
of the smartphone. Fix the smartphone in the desired posi-
tion by re-tightening the locking screw 3.
♦
If necessary, attach the remote release 8 to the lower part of
the telescopic shaft 4 using the remote release holder r.
│
■
10
GB
button e for about
SSBS 3.0 A1