Teka CNL 6400 Guía De Uso página 20

3. The third speed is timed, so the cooker
hood will automatically revert to the second
speed after seven minutes.
Programming stop delay timer
1. Programming Timer
a. Open Tray with motors switched on or off
b.
flicker quickly.
c.
Each LED represents
operating time. The maximum operating
Before carrying
maintenance activities,
extractor is disconnected from the mains.
To carry out cleaning and maintenance, follow
the Safety Instructions.
Fire risk exists in case that cleaning does not
take place according to the instructions.
Filter cleaning
To withdraw the filters from their locations
release the anchoring points. Clean the filter,
either by putting it in the dishwasher (see
notes) or leaving it standing in hot water to
simplify the removal of grease or, if wished, by
means of special sprays (protecting the non
metallic parts). Once clean, leave it to dry.
Attention: the cooker hood will not work until
the main filter was reinstalled.
Notes: cleaning in the dishwasher with
aggressive detergents
surface of metallic parts, without this affecting
its gas retaining properties.
20
5 minutes
out any cleaning
ensure that
may blacken
time is 15 minutes (the LED corresponding
to the intensive speed starts flickering fast).
d. 5 seconds after pressing the keys, the LED
corresponding to the time stops flickering
fast and the LED corresponding to the
selected speed starts flickering slowly.
e. In stop delay timer Mode, speeds can be
2. Cancellation of Stop Delay Timer:
or close the tray.
Lighting
The lighting can be switched on or off by
When you pull the tray, the lighting is switched
of
on or off, depending on how it was the last
time.
or
N.B. The filter must be cleaned at least once a
the
month depending on how often the extractor
is used. It must be remembered that grease is
deposited in the extractor when cooking,
whether it is switched on or not.
Cleaning of the extractor body
The use of warm (40ºC approx.) soapy water
is recommended. A cloth moistened in this
water is used for cleaning the extractor, paying
special attention to the grids. Afterwards, dry it
using a lint-free cloth.
Note:
 Never use metallic scouring pads or
abrasive products that could damage the
surface.
 Do not use scrapers with metallic surfaces
such as knives, scissors etc.
Activated charcoal filter
the
 To install the charcoal filter, the motor
anchorage is made to coincide with the
anchor points of the activated charcoal
filter and turn it clockwise.