Abus NVR10040 Guide Rapide página 20

4 5
Set the adapter speed tye ‚NIC type' If you wish the address data to be
manually. Default and recommended automatically
setting is the automatic detection (Self "Enable DHCP" checkbox. The addresses
adaptive). will then be automatically assigned
by your router (where supported).
If proceeding in this way, move on to
point 13.
38
6
192.168.0.20 192.168.0.25
192.168.0.1
If your router does not automatically
assigned, tick the assign the address data, enter the
data according to the following steps.
The image gives an example of con-
nected devices with the corresponding
IP addresses.
English
7 8
The first three positions of the IP The subnet mask is a network segment
address must correspond to the in which IP addresses with the same
default gateway value. The final digit network address are used. The standard
identifies devices addressed by the value is normally 255.255.255.0 in
default gateway and is individually set such cases. To determine the value for
for each device. For the recorder, the default gateway, use a Windows PC
choose e.g. 64: i.e. xxx.xxx.xxx.64. connected to the network.
English
9
Enter the IP address of your router
here. You can find the address with
"cmd" and the command "ipconfig"
on your Windows PC.
39