Flex FX1351 Manual Del Operador página 13

Atornillador de impacto sin escobillas de 24 v
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
product damage due to a short circuit, never
immerse your tool, battery pack or charger
in fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and
bleach or bleach-containing products, etc. can
cause a short circuit.
WARNING
this product until the parts are replaced. Use
of this product with damaged or missing parts
could result in serious personal injury.
This impact driver must be used only with the battery packs and chargers listed below:
2.5Ah
5Ah
FLEX FX0111
FLEX FX0121
NOTICE: Please refer to the battery pack and charger manuals for detailed operating
information.
TIGHTEN AND LOOSEN SCREWS, NUTS
AND BOLTS (FIG. 9)
Variable-speed control must be used with
caution for driving nuts and bolts using socket
set attachments. The best technique is to start
slowly, increase speed as the nut or bolt runs
down, and then set the nut or bolt snugly by
slowing the tool to a stop. If this procedure is
not followed, the tool will have a tendency to
torque or twist in your hand when the nut or bolt
seats.
a. Install a suitable bit.
b. Apply just enough pressure to keep the bit
engaged on the screw or nut.
c. Apply minimal pressure to the variable-speed
trigger switch initially. Increase the speed only
when full control can be maintained.
NOTICE:
a. Always use the correct type and size of bit for
your application.
b. When turning in a screw at/near the crosscut
end or an edge of wood, pre-drill a hole in
order to avoid cracking of the wood.
c. When screw driving in hard wood, one should
pre-drill a pilot hole.
OPERATING INSTRUCTIONS
To reduce the risk of fire,
personal injury, and
If any parts are damaged
or missing, do not operate
Battery Pack
8Ah
FLEX FX0221
WARNING
accessories not recommended for use with
this tool. Any such alteration or modification is
misuse and could result in a hazardous
condition leading to possible serious injury.
WARNING
serious personal injury, always remove the
battery pack from the tool when assembling
parts.
12Ah
FLEX FX0231
Fig. 9
WARNING
can break the fastener. Keep the impact
driver at a right angle to the fastener to
avoid damaging the fastener head.
-13-
Do not attempt to modify
this tool or create
To prevent accidental
starting that could cause
Charger
FLEX FX0411
FLEX FX0421
Do not over-tighten, as the
force of the impact driver

Publicidad

Tabla de contenido
loading

Tabla de contenido