schmalz SCTMi Instrucciones De Funcionamiento página 39

Value range 0x00 = control is not active, H1 in hysteresis mode
0x01 = control is not active, H1 in comparator mode
0x02 = control is active
0x03 = control is active with supervision of leakage
0x04 = control is active, continuous succing disabled
0x05 = control is active with supervision of leakage, continuous succing disa-
bled
Default value 0x02 = control is active
Unit -
EEPROM yes
Modo de soplado de los eyectores
Parameter 110 (0x006E)
Description Blow-mode for ejectors
Index 0...15 Index corresponds to ejector number #1...#16
Datatyp uint8
Length 16 Byte
Access read/write
Value range 0x00 = externally controlled blow-off
0x01 = internally controlled blow-off – time-dependent
0x02 = externally controlled blow-off – time-dependent
Default value 0
Unit -
EEPROM yes
Tensión de alimentación del sensor
Parameter 66 (0x0042)
Description Primary supply voltage
Index 0: actual value as measured by the device
1: min. value since last power-up
2: max. value since last power-up
Datatyp uint16
Length 6 Byte
Access read only
Value range -
Default value -
Unit 0.1 V
EEPROM no
Tensión de alimentación del actuador
Parameter 67 (0x0043)
Description Auxiliary supply voltage
Index 0: actual value as measured by the device
1: min. value since last power-up
ES · 30.30.01.01598 · 02 · 01/19
Interfaces
39 / 72