Steren AMP-020/GTR Manual De Instrucciones página 5

9.- REVERB
Use it to increase or decrease the reverb effect, which can be applied to
the original dry signal. By increasing the reverberation (REVERB) effect
guitar sounds looks like if you were playing in a large hall. There is no
need to raise the level of reverb too much to produce sound impressive. The
reverberation does not stop as long as active this effect.
It controls the amount of reverberation effect.
14 15
10.- Indication of low tone.
Turns on when the pitch is below
of the correct level
10
11.- Display
12.- Instrument selector
It allows to select a device
to calibrate it. You can select
between Guitar or Bass.
11 13
12
13.- On/off switch
14.- Calibrate pitch LED indicator
15.- High tone light indicator.
Turns on when the pitch is over the correct level.
ENGLISH-05