Burner And Orifice; Leak Testing - Disposable Lp Gas Cylinders; How To Check For Leaks; Fixing A Fuel Leak - Coleman 9949A Serie Manual De Uso, Cuidado Y Ensamblaje

Burner and Orifice

■ Proper location of the burner with respect to the orifice is
important. To verify the proper installation of the venturi
tube, use a screwdriver to remove the grill top. The
venturi tube must be located over the orifice fitting. See
Fig. 26 (grill top not shown).
Fig. 26
Burner
Venturi Tube
■ Check and clean the burner/venturi tubes for insects and
insect nests. A clogged tube can lead to a fire beneath
the appliance.
Leak Testing - Disposable LP Gas
Cylinders
T P F e
o revenT ire or xPlosion
• NO SMOKING. DO NOT use or permit sources of
ignition in the area while doing a leak test.
• Perform leak tests outdoors only.
• NEVER perform a leak test with fire or flame.

How to Check for Leaks

1. Make a soapy solution of equal parts mild liquid
dishwashing detergent and water.
2. Turn off all burner control knobs.
3. Apply a soap solution to the connections
indicated with the arrows. (Fig. 27) If bubbles
appear at these areas, a leak is indicated.
No Smoking
No Flame
Orifice Fitting
DANGER
H :
azard

Fixing A Fuel Leak

If you detect a leak:
1. Stop a leak by tightening the loose joint, or by replacing
the faulty part with a replacement part recommended
by Coleman. DO NOT attempt to repair the cylinder if it
should become damaged; the cylinder MUST
be replaced.
2. If you are unable to stop a leak, remove the cylinder from
the grill. DO NOT use the grill until the leak is corrected.
When to test for leaks:
1. Perform a leak test each time the gas supply cylinder is
connected to the regulator. Leak test anytime a part of
the gas system is replaced.

Start-Up Check List

Failure to follow these safety steps before using the grill
each time could result in a fire that could be hazardous to
you, your appliance or property. It is especially important
to observe these steps after the grill has been stored,
moved or cleaned.
1. Regularly check the burner venturi tubes for blockage
from an insect nest. Read "Cleaning the Venturi" in the
section titled "Care, Maintenance, and Cleaning", and
also the section titled "Troubleshooting".
2. Check that all the burner venturi [A] are set over the valve
outlets [B] correctly. The valve orifice [C] must be inside
the venturi. (Fig. 28)
3. Use only the gas specified.
4. Keep the grill on a level surface.
5. Keep the grease pan empty at start up.
Fig. 28
DO NOT add charcoal or lighting fluid!
Fig. 27
English-8
WARNING
A
B C
REPRESENTATIVE ILLUSTRATION
CAUTION