Installing 1 Lb. Propane Cylinder; Burner And Orifice - Coleman 9955 Serie Manual De Uso, Cuidado Y Montaje

Install the Drip Tray
■ Install drip tray below
rear of grill. (Fig. 15)
Install the Electrode and Ground Wires
■ Plug the round electrical connector to the round jack at
the end of the electrical igniter, and insert the flat one
through the burner tube hole, then screwed with screw.
(Fig. 16 and Fig. 17)
Burner Tube
Hole
Round
Flat
Fig. 16

Installing 1 lb. Propane Cylinder

NOTE: Your 9955 Series grill is set up from the factory to
use a 1 lb. disposable propane cylinder.
Only cylinders marked "Propane" must be used.
This procedure MUST be performed OUTDOORS only!
Read and follow the directions on the cylinder.
NEVER store a spare L.P. gas supply cylinder under the
grill body or inside the grill enclosure or in the vicinity of
any heat producing appliance.
Failure to follow this information exactly could result in an
explosion and/or fire causing death or serious injury.
WARNING
WARNING
DANGER
Tighten by hand only. DO NOT use tools.
■ Before attaching propane
cylinder make sure
burner knob is in the OFF
position. (Fig. 18)
Fig. 15
■ Remove plastic cap from
top of propane cylinder
and screw cylinder into
regulator hand tight.
(Fig. 19)
■ To open lid, unlatch
handle cover and lift up.
(Fig. 20)
Fig. 17
■ Place grill grate over the
burner. (Fig. 21)
Burner and Orifice
■ Proper location of the burner with respect to the orifice is
important. To verify the proper installation of the burner
tube, view under the regulator assembly cover. The
burner tube must be located over the orifice fitting. See
Fig. 22 (grill top not shown).
Burner
English - 5
CAUTION
Burner Tube
Orifice Fitting
Fig. 18
Fig. 19
Fig. 20
Fig. 21
Fig. 22