Toxic And/Or Dangerous Liquid Dosage; Assembling And Dismantling The Pump; Assembly; Dismantlement - CTX MyPOOL Serie Normas De Instalacióin, Uso Y Manutencióin

1.5 -

TOXIC AND/OR DANGEROUS LIQUID DOSAGE

To avoid risk from contact with the hazardous liquids or toxic fumes, always adhere to the notes in this instruc- tion manual:
• Follow the instructions of the dosing liquid manufacturer.
• Check the hydraulic part of the pump and use it only if it is in perfect condition.
• Use only the correct materials for the tubing, valves and seals to suit the liquid to be dosed; where possible shield the tubing with PVC
conduit.
• Before disconnecting the metering pump, make sure to flush out and neutralize the pump head with the proper reagent liquid.

1.6 - ASSEMBLING AND DISMANTLING THE PUMP

1.6.1 - ASSEMBLY

All metering pumps are normally supplied fully assembled. For greater clarity, please consult the exploded view of the pump appended at
the end of the manual, which shows all the pump details and a complete overview of all the pump components. These drawings are in any
case quite indispensable whenever defective parts have to be re-ordered. For the same purpose, the appendix also contains other drawings
showing the hydraulic parts (pump head and valves).

1.6.2 - DISMANTLEMENT

Proceed as follows before you dismantle the pump or before performing any other operation on it:
1. Disconnect the pins from the mains or by means of a two poles switch with 3 mm minimum distance between the contacts.
2. Relieve all the pressure from the peristaltic pump and injection tube.
3. Drain or flush all dosing liquid from the peristaltic.
This operation calls for special attention, and you should therefore consult the drawings in Appendix and
Chapter 1.4"RISKS" before you commence work
15