Toro Flex-Force Power System 51820 Manual Del Usuario página 14

Problem
It is difficult to remove the battery pack
from the tool.
The speed lock does not hold when
engaged.
Possible Cause
1. The battery pack/tool is new or there
is corrosion in the battery terminals
and/or the terminals on the tool.
1. The speed lock screw is loose.
12
Corrective Action
1. Clean the terminals on the battery
pack and the tool with a dry rag. Then
apply dielectric grease to the battery
terminals; do not use any other type
of lubricant as it can damage the
terminals.
1. Tighten the speed lock screw by
turning the speed lock screw ¼ turn. If
the speed lock still does not hold when
engaged, turn the speed lock screw an
additional ¼ turn.