Setting Date And Time - Tintometer Lovibond MD200 Instrucciones

GB Menu options
PrtG
On
Off
E 132
Store Date
2
3
Time Cal
Mode
SET
DATE
YYYY
(2 sec.)
Mode
Zero
Test
!
MD200_1a 08/2011
notch for IR
data transfer
The IRiM Module and the connected printer/PC must be ready. Press
the [MODE] key to start the transmitting, the instrument displays
"PrtG" (Printing)for approx. 1 secondfollowed by the number of the
first data set and its transmission. All data sets will be transmitted
one after the other. After finishing the instrument switches to test
mode.
The print job can be cancelled by pressing the [On/Off] key. The
instrument switchesoff.
If the instrument isnot able to communicate with the IRiM,a timeout
occursafter approx. 2 minutes. Theerror E132 isdisplayed for approx.
4 seconds. Subsequently, the instrument switches to test mode (see
also IRiM manual).
3
Setting date and time (24-hour-format)
2
After confirming the selection with the [MODE] key the value to be
edited will be shown for 2 sec.
The setting starts with the year (YYYY) followed by the actual value
to be edited. The same applies for month (mm), day (dd), hour (hh)
and minutes (mm). Set the minutes first in steps of 10, press the [!]
key to continue setting the minutes in steps of 1.
Increase the value by pressing the [MODE] key.
Decrease the value by pressing [ZERO/TEST]key.
Proceedto the next value to be edited by pressing [!] key.
After setting the minutesand pressingthe [!] keythe displaywill show
"ISSET" and the instrument returns to the measurement mode.
21