C - Fitting The Winch's Handle; D - Maintenance Of The Easy Pro Levpano - EasyPro LEVPANO 513600 Manual De Instrucciones Y Mantenimiento

C – FITTING THE WINCH'S HANDLE
NOTE : For reasons of convenience and safety during transport, the winch's handle (item 1) is supplied dismantled.
Handle fitting instructions
1) Fit the handle (item 1) on its pin, bringing it as far as it will go against the washer (item 2) (without applying
force). Lock the winch's coil to perform this operation.
2) Fit the washer (item 3), onto the screw (item 4), then screw the latter on the handle's pin and lock it. Lock also
the winch's coil to perform this operation.

D - MAINTENANCE OF THE EASY PRO LEVPANO

1) General maintenance
Check the following parts at regular intervals, according to the indications given in the table below:
- The condition of the cables, pulleys and pulley pins,
- The condition of the rubber stops and shoes,
- The conditions of the wheels and the operation of the
wheel brakes,
- The fixing and clamping devices
- The cleanness of the columns,
- The condition of the winch and its function (see § 2)
- The condition of the head and its function (see § 3)
And replace if necessary.
Any defective cable must be replaced by a guenuine cable.
Characteristics of the cables: diameter 3 mm, composition: 7 x 19 wires, actual breaking load : 5.75 KN
2) Maintenance of the winch :
The winch requires regular servicing by a competent department. Regular cleaning makes for a longer
service life.
- Never work with a defective cable.
- Keep the pinions, bearings and reel pin well greased. Use a Molydal N° 3790 type grease
PARTS
®
FREQUENCY
Week Month
X
X
X
X
X
X
X
13
TYPE OF
VERIFICATION
Visual Test Lubrication
check
X X
X
X X
X
X X
X X X
X X X
.