Toyotomi Zibro RC-320 Instrucciones De Uso página 4

geneRal diRections foR Use
Below you will find the main steps to be taken for
using your heater. For more details, please refer to
the MANUAL.
1
Remove all packaging materials (refer to Section A, Fig. A).
2
Fill the removable tank  and wait 30 minutes before you
ignite the heater (refer to Section B, Fig. I).
3
Insert the batteries into the battery holder 
(refer to Section A, Fig. F).
4
Check whether the combustion chamber  is fully upright (refer
to Section A, Fig. E).
5
Ignite the heater by turning the knurled wick adjustment knob 
as far to the right as possible
(refer to Section C, Fig. L).
6
After igniting the heater it will take 30 minutes before you can
check if the heater burns well (refer to Section D).
7
Switch off the heater (refer to Section E).
•
As a fire precaution, the tank must be filled either when the heater has been
switched off or in another room than the room where the heater is installed.
•
Always ensure that the tank is closed properly after filling it at a safe distance from
all sources of heat and open flames (see chapter B).
•
The first time you ignite your heater it will smell like 'new' for a short time.
•
Store all fuel containers with their original caps and seals in a cool and dark place.
•
Fuel ages. Use new fuel at the start of every heating season.
•
Only use high quality and water-free pure paraffin in accordance with local
legislation.
•
Before changing brands and/or types of fuel make sure that the mobile heater first
completely empties all of the remaining fuel inside the heater.
4
3