Grouw 18023 Manual De Instrucciones página 78

1. Log Pusher
2. Work Table
3. Wedge
4. Lift Handle
7. Switch
8. Motor
9. Pushbutton Box
10. Wheels for Minor Moving ONLY.
11. Hydraulic Control Lever
12. Control Lever Guard
13. Bleed Screw
14. Oil Drain Bolt w/ Dipstick
Before operating the log splitter, the
Bleed Screw should be loosened by some
rotations until air can go in and out of the
oil tank smoothly.
Air � ow through the Bleed Screw hole
should be detectable during the log splitter
is under operations.
Before moving the log splitter, make sure
the Bleed Screw is tightened to avoid oil
leaking from this point.
FAILED TO LOOSEN THE BLEED
SCREW WILL KEEP THE SEALED
AIR IN HYDRAULIC SYSTEM
BEING COMPRESSED AFTER
BEING DECOMPRESSED. SUCH CONTINUOUS
AIR COMPRESSION AND DECOMPRESSION
WILL BLOW OUT THE SEALS OF THE
HYDRAULIC SYSTEM AND CAUSE
PERMANENT DAMAGE TO THE LOG SPLITTER.
15. Max Pressure Limiting Screw
DO NOT ADJUST THE MAX
PRESSURE LIMITING SCREW !
Max pressure was set before the log splitter
ex work and the max pressure limiting screw
is sealed with glue to ensure the log splitter
works under pressure no more than 5 tons.
78
The setting was done by quali� ed mechanic
with professional instruments.
Unauthorized resetting will cause the
hydraulic pump fail to output enough
splitting pressure or RESULT IN SERIOUS
INJURY AS WELL AS DAMAGE TO THE
MACHINE .
DO NOT
ADJUST THE
MAX PRESSURE
LIMITING SCREW !