Replacing Hydraulic Oil - Grouw 18023 Manual De Instrucciones

REPLACING HYDRAULIC OIL

Replace the Hydraulic oil in the log splitter
after every 150 hours of use. Take following
steps to replace it.
- Make sure all moving parts stops and the
log splitter is unplugged.
- Unscrew Oil Drain Bolt with Dipstick to
remove it.
- Turn the log splitter on the Support Leg
side over an 4 liters capacity container to
drain the hydraulic oil off .
- Turn the log splitter on the the motor
side.
- Re� ll fresh hydraulic oil at the volume
as per the hydraulic oil capacity of a
particular model indicated in above
speci� cations table.
- Clean the surface of Dipstick on the Oil
Drain Bolt and put it back into the oil
tank while keep the log splitter vertically.
- Make sure the level of the re� lled oil
is just between 2 grooves around the
Dipstick.
- Clean the Oil Drain Bolt before thread
them back. Make sure they are tightened
to avoid leakage before place the log
splitter horizontally.
Periodically check oil level to ensure it is
between 2 grooves around the Dipstick.
Upon Lower oil level, oil re� lling is required.
Following hydraulic oils or equivalent are
recommend for the log splitter's hydraulic
transmission system:
SHELL Tellus 22
MOBIL DTE 11
ARAL Vitam GF 22
BP Energol HLP-HM 22
SHARPENING WEDGE
After using the log splitters for some time,
sharpen the wedge of the log splitter using
a � ne-toothed � le and smooth any burrs or
crushed area along the cutting edge.
GB
81