Ironing With Steam; Ironing Without Steam; Shot Of Steam; Vertical Steam - Bosch Sensixx’x DI90 MotorSteam Instrucciones De Uso

5
Ironing with steam
The steam control is used to adjust
ℹ ℹ
the amount of steam produced when
ironing (see "Setting the steam amount"
section).
Steam can be generated in two ways :
a. Continuous steam generation :
1. Set the steam control to "eco" or "max"
position.
2. Grip the handle (1).
B. Steam on demand*:
(only on models equipped with steam
ℹ ℹ
activation button).
1. Set the steam control to the
cancel continuous steam generation while
gripping the handle (1). On this setting, steam
can only be produced when manually pressing
the steam activation button (2*) under the
handle.
2. Press the steam activation button.
While the pump is working, the lights (17)
ℹ ℹ
at rear of the water tank go on.
Important :
ℹ ℹ
Steam is only available if the temperature
control (15) is set at the steam
symbols -
The steam flow may vary depending on the
soleplate temperature.
☞ ❐
Tip: for better ironing results, iron the last
strokes without steam to dry the garment.
6
Ironing without steam
This enables the iron to be used for dry
ℹ ℹ
ironing.
1. Grip the handle (1) and set the steam control
to the setting.
2. The temperature control (15) adjusts the
temperature of the soleplate (13). Set it to the
corresponding position by lining it up with the
temperature index (14) on the iron.
Select an appropriate temperature for the
type of material being ironed (see "Setting the
temperature" section).
3. While ironing, do not press the steam
activation button (2*).
20
B O SC H
position, to
between "••" and "max".
7
Spray
This can be used to remove stubborn
ℹ ℹ
wrinkles.
☞ ❐
Do not use the spray function with silk as
staining may occur.
1. Select an appropriate temperature for the
type of material being ironed (see "Setting the
temperature" section).
2. When ironing, press the spray button (7) and
water will spray out of the spray nozzle (10)
onto the garment.
8
Shot of steam
☞ ❐
This can be used to remove stubborn
wrinkles or to press in a sharp crease
or pleat.
1. Set the temperature control (15) to "max".
2. Press the shot of steam button (6) on the
handle repeatedly at intervals of 5 seconds.
9
vertical steam
This can be used to remove creases
ℹ ℹ
from hanging clothes, curtains etc.
E E
Do not iron clothing while it is being
worn!
E E Never spray or aim the steam at persons
or animals!
1. Set the temperature control (15) to "max".
2. Hang article of clothing on a clothes hanger.
3. Operate the iron in a vertical position at a
distance of 10 cm / 4 in, and press the shot of
steam button (6) repeatedly with pauses of at
least 5 seconds.