Bosch Sensixx’x DI90 MotorSteam Instrucciones De Uso página 24

problem
Water drips out
of the soleplate
together with
steam.
Steam does
not come out in
horizontal position.
Excessive dripping
or steaming.
The pump does
not work
Spray does not
work.
Smoke comes out
when connecting
the iron for the first
time.
Deposits come out
through the holes
in the soleplate
The appliance
makes a pumping
sound
If none of the above solves the problem, get in touch with an authorised technical service.
You can download this manual from the local homepages of Bosch.
24
B O SC H
probable cause
1. Temperature control (15) setting is too
low.
2. You have pressed the shot of steam
button (6) repeatedly without waiting
for 5 seconds between each press.
3. Pure distilled water has been used
(see "Filling the water tank" section)
or other products such as fragrant
water have been added to the tank.
1. Steam control is set to " " position.
2. No water in the tank (11).
3. The temperature is too low. Anti-drip
system is activated.
• No proper closing of "Calc'nClean"
system.
• The iron is not in a horizontal position. • Use the iron in a horizontal
1. No water in the tank (11).
2. Obstructed mechanism.
• This may be caused by the lubrication
of some of the internal parts.
• Traces of lime scale are coming out of
the steam chamber.
• Water is being pumped into the
steam chamber
Solution
1. Turn the temperature control (15)
to a higher setting (between "●●"
and "max") and wait until the
"TempOK" lights inside the
temperature control stop flashing
and remain lit continuously.
2. Wait 5 seconds between each
press of the shot of steam button.
3. Mix distilled water with tap water
as directed in the "Filling the water
tank" section and never add any
other products to the water tank
(unless recommended by Bosch).
1. Set the steam control to "eco" or
"max" position.
2. Fill the tank (11).
3. Set to a higher temperature if
compatible with the fabric.
• Actuate a few times the
"Calc'nClean" button (16).
position.
1. Fill the water tank.
2. Contact the Technical Service.
• This is normal and will stop after a
few minutes.
• Carry out a cleaning cycle (see
"Calc'nClean" section).
• This is normal.