Whirlpool SPIW309A3WF.1 Instrucciones Para El Uso página 7

What can I do if my wireless connections
does not reach the air conditioner?
I changed the router, what do I have to do?
What can I do if the Connection State
indicator continues to blink slowly and
never lits solid on?
conditioner?
How to set up the wireless connection on
your appliance?
How to check if data is being transmitted?
The manufacturer, Whirlpool EMEA S.p.A., declares that this SPIW309A3WF.1, SPIW312A3WF.1, SPIW309A2WF,
SPIW312A2WF, SPIW318A2WF
compliant with directive 2014/53/UE
The complete text of declaration of conformity is present at the following website:
docs.whirlpool.eu
coverage as: Access Point, WiFi repeaters and Power-line
bridge (not provided with air conditioner).
You can either maintain the same set up properties (network
name and password) or erase the previous set up from the
appliance (reset process) and carry out the setup again (see
"Live-Remote Control/Setup procedure").
air conditioner has been successfully connected to the router,
but it is not able to connect the Internet. In order to get the
appliance connected to the Internet, you have to check the
router and/or the bearer settings.
Correct router settings: NAT must be on, Firewall and DHCP
must be properly set. Password cryptography supported: WEP,
WPA,WPA2. Please refer to router manual.
Bearer settings: if Your Internet service provider has
established the numbers of MAC address able to connect to
the Internet, you may not be able to connect air conditioner to
e.g the one of your computer. Please ask your Internet service
provider about the procedures to connect a new device other
then a computer (e.g a air conditioner) to the Internet.
On your Smart Appliance: • on the air conditioner there is
sticker label with SAID & MAC address The MAC address is
made by combination of numbers and letters.
See detailed IFU, there are 2 alternative approach on each
appliance: 1. use the WPS (WiFi Protected Setup) connection
minutes from appliance switch on it is active a web page for
the appliance (WP_"MAC Address", example
AIRCON_88_E7_12_00_28_3C).
the appliance, verify that the App shows the UI status of the
appliance. Set Jet or another option and verify on the App
the status (NOTE: temperature setting takes several seconds
before it is delivered to the App).
7