Bimar CIGNO S907.EU Folleto De Instrucciones página 8

Fax +32 030 9904733

Make sure that the fan heater is working correctly: if not, turn the heater off and have it checked by
professionally qualified personnel.
Make sure that the air-intake grid is not obstructed by objects, fabrics or anything else to avoid the
heater overheating or breaking.
Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly. Check that no other high absorption appliances are connected to the same
power source.
In the case of a breakdown or fault, switch off the appliance and have it checked by a
professionally qualified technician; repairs made by unqualified persons can be dangerous and
render void the warranty.
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the
power cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician
or a person with similar qualifications, in order to avoid any risk.
To use the thermofan, please follow the instructions below:
1) Insert the plug in the current socket.
2) To switch the appliance on, turn the selector knob to the position corresponding to the desired
function:
"0"= OFF;
" "= air warm (1000W), low speed (sleep function)
" "=air warm (1000W), high speed;
In addition, the switch also adjusts the thermostat; turn the knob all the way anticlockwise to select
the function that activates at least about 5 ° C, the temperature reaches about 5 ° C and is kept
constant, then when the temperature exceeds 5 ° unit turns off.
Ion function: produces a stream of negative ions that neutralize the positive ions present air, ionizing
function is less obvious in environments with high humidity. This function is activated every time you
select the rear dial (6) in pos. "
If you wish the oscillation function, turn the oscillation button (6), in pos. "
3)
oscillation (i.e., 90° rotation alternatively right and left).
To turn off the fan heater, please turn the Knob in the "0" position clockwise and press the rear
4)
switch in pos."OFF". Then pull out the plug from the socket.
Never leave the appliance connected to the socket if it is not in use, especially for long periods .
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
" "= fan
" and "
Assembly page 8/24
" "=air very hot (2000W)
"
8 24
/
" and