Control Panel Guide - EnviroBoss EB80 Manual De Instrucciones

Error messages
If the EB80 onboard diagnostics discover a problem, the
unit will display an error message. See "Error Messages"
for an explanation of each message.

Control Panel Guide

ON/OFF. Press to turn the unit on or off. When the ma-
chine is turned on, the display normally reads PLEASE
WAIT COMP. DELAY and performs a numeral count-
down for a maximum of 60 seconds to 0. This delay al-
lows time for refrigerant pressures to equalize for easier
starting. Once the unit completes the compressor delay,
the display shows UNIT ON XX HRS and cycles be-
tween INLET XX°F and INLET XX%. NOTE: If no com-
pressor delay countdown is displayed, a delay is not
necessary and the machine will begin operation immedi-
ately.
DISPLAY MENU. Press to cycle through the display of
additional dehumidifier conditions and User Settings. To
return to the main menu, press the ON/OFF key once.
MENU SELECTION. Press to change the values of the
"User Defined" settings. The MENU SELECTION key
acts as the UP key for adjusting the setpoint for Humidi-
stat mode operation. See User Settings Menu.
PURGE. Press to empty water from the condensate
pump reservoir. The display will read PUMP PURGING
with a numeral countdown.
NOTE: During normal operation, the pump purges auto-
matically.
07-02331B EB80
CONTROL PANEL
DISPLAY
ON/OFF
ON/OFF
DISPLAY MENU
MENU SELECTION /
UP KEY
PURGE PUMP
3
PURGE PUMP
MENU SE-
DISPLAY
LECTION /
MENU
UP KEY
Press and release to turn unit
on
or off.
Press to select next item in
menu. Menu item will show
in display.
Press to toggle or select val-
ues in menu displayed.
Press and release to start
purge. Display will count
down seconds remaining until
purge is complete.
EnviroBoss.