Silvercrest SGM 110 A1 Instrucciones De Uso página 32

9) Press the "Start" button
continuously green.
The appliance starts to blend and heat the ingredients.
NOTE
► If you remove the mask mould
process, warning beeps sound and the indicator lamp
The preparation of the face mask continues, however the mask fluid is not
dispensed. The pouring-out process will not start until the mask mould
placed correctly underneath the appliance and the face mask is properly
mixed.
► You can also stop the process by pressing the "Start" button
A beep sounds and the indicator lamp
from the mains power socket and carefully tip out the liquid in the appliance.
Clean the appliance as described in the section "Cleaning".
After approx. 6 minutes, the mask is properly mixed and the mask is now poured
automatically into the mask mould
NOTE
► Preparation time can vary according to the starting temperature and type
of the ingredients!
Approx. 20 seconds after the face mask is poured into the mask mould
beeps are sounded. The beeps stop as soon as the mask mould is removed from
the appliance. Remove the plug from the mains power socket.
10) Slightly tilt the mask mould
11) If you want to make a refreshing face mask, place the mask mould
in the fridge and wait for it to cool.
If you want to make a warm face mask, wait for around 5 minutes until the
mask has set.
NOTE
► The gel time can vary considerably depending on the type of ingredients used.
12) Carefully remove the face mask from the face mould
teaspoon or similar at the edge of the mask mould
mask out of the mask mould
NOTE
► Test the mask on an unobtrusive spot first in order to establish skin com patibility.
SGM 110 A1
. A beep sounds and the indicator lamp
from the appliance during the preparation
flashes green. Remove the plug
. The indicator lamp
in order to ensure ideal distribution of the liquid.
.
illuminates
lights orange.
is
for 5 seconds.
flashes green.
, long
carefully
. To do this, insert a
and carefully lift the
29 ■
GB│IE
│