Connecting USB devices (Fig. 9)
CAUTION:
• Connect only devices which are compatible with the
USB power supply port. Otherwise it may cause
malfunction to the battery holder.
The battery holder (with the battery) can work as an
external power supply for USB devices.
Open the cover and connect the USB cable (not included)
with the power supply port (10) of the battery holder. And
then connect the other end of the cable with the device.
The battery holder (with the battery) supplies DC5V, 2.1A
by one port, and 3.0A in total by two ports.
The USB cable can be placed inside the jacket for
convenience by using the hole of the pocket and cable
holder (Fig. 10).
NOTE:
• Before connecting USB device to the battery holder
(with the battery), always backup your data of USB
device. Otherwise your data may be lost by any
possibility.
• The charger may not supply power to some USB
devices.
• Wait for 10 seconds before charging another device
consecutively.
• When not using or after charging, remove the USB
cable and close the cover.
MAINTENANCE
CAUTION:
• Always be sure that the jacket is switched off and the
battery cartridge is removed before attempting to
perform inspection or maintenance.
If jacket does not switch on or any fault is found with a
fully charged battery cartridge, clean the terminals of
the battery holder and the battery cartridge. If jacket
still does not work properly, stop using the jacket and
contact our authorized service center.
OPTIONAL ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Makita genuine battery and charger
NOTE:
• Some items in the list may be included in the package
as standard accessories. They may differ from country
to country.
6