Para Activar Una Tecla Macro; Parking Control With Lightsys Gate Control Keyfobs; Assign New Keyfob - RISCO Group LightSYS Manual De Usuario

Nota:
Usted también puede usar las teclas
programar las teclas Macro Use las teclas
6. When you have finished entering the series of characters, ensure that the cursor is
placed in the field after the last character in the series, and press A (or the function
key you selected in step 4) again. The series of characters is saved and assigned to the
selected function key

Para Activar una tecla Macro

Presione la tecla numérica
A/B/C/D respectivamente.

Parking Control with LightSYS Gate Control Keyfobs

If your system is equipped with wireless receiver it can support up to 200 keyfobs that can
be used for controlling two outputs for gate and parking control. These keyfobs are
additional to the keyfobs that can be used to control the security applications of the
system. Each keyfob had a dedicated button to support each output.
The Grand master or the installer can control the management of these keyfobs
Notas:
The following procedures are relevant only for stand-alone keyfobs. The keyfobs that control the
security system can be defined and programmed only by your installer.
Your installer must define the outputs and the way they will operate so you can perform the following
procedures.

Assign New Keyfob

1. Press and enter Grand Master code followed by
2. Using the arrow keys, scroll to the option Stand Alone KF and press
3. Select the receiver that you want to assign the keyfob to and press
4. Using the arrow keys, scroll to the New Keyfob option and press
5. Press the
6. Press the keyfob
7. Repeat step 6 for additional keyfobs. When finished press
mode.
/ /
key to start the keyfob registration mode.
key for 3 seconds.
Funciones y Configuraciones de Usuario
y para introducir números al
y
por 2 segundos para activar la Macro
/
Page 41
para mover el cursor
.
.
.
.
to exit registration
Manual de Usuario de Agility