Sony SU-FL300 Manual De Instrucciones página 6

Step 2:
Assembling the TV
Stand
WARNING
If you allow the AC power cord to be pinched under or
between pieces of equipment, this may result in a short
circuit or an electric shock. If you stumble over the AC
power cord or the connecting cable, the TV Stand may
topple over and cause injury.
Decide on the installation location and lay the TV
Stand down before installing the TV.
Since the TV is heavy, it is recommended that you decide
on the installation location beforehand, and assemble the
TV Stand on site.
1
Attach the Rear Pillar to the Base
Board.
1 Tighten the two supplied Cam-lock screws to the
Base Board.
Cam-lock screw
Base Board
Arrow direction shows front of the TV Stand.
6
(GB)
2 Attach the Rear Pillar to the Base Board and secure
the two Cam-locks with a screwdriver.
Cam-lock*
* Before attaching the Rear Pillar, make sure that the
F mark points downward.
2
Attach the Side Pillars to the
Base Board.
Secure the Side Pillars and the Base Board with the
four supplied screws (+PWH5 × 25).
Side Pillar (R)
Note
There are differences between the left and right pillars.
Be sure to install each pillar on the correct side.
Rear Pillar
Side Pillar (L)
Screw
(+PWH5 × 25)