Nolan N100E Seguridad E Instrucciones página 14

2 Fitting
To refit the inner comfort padding, reverse the order of point 1.6 and 1.1 operations:
2.1 Correctly insert the inner padding into the helmet.
2.2 Insert the visor fixing front flaps into the shell support, by gently pushing the liner
towards the helmet outside (Fig. 12).
2.3 Insert the right-hand and left-hand side flaps into the inner comfort padding by push-
ing them between the inner shell and the outer shell (Fig. 11).
2.4 Insert the left- front- and right-hand padding rear flaps in the special support in the
nape area (Fig. 10). To do this, gently work the shell edge seal and push until you hear
the locks go click.
2.5 Insert the band and the left chin strap in the special slot in the left cheek pad (Fig. 9).
2.6 Insert the rear flaps of the left cheek pad between the outer and the inner shells; push
the cheek pad towards the back of the helmet and insert the roll-neck snap button
located on the back of the cheek pad into the slot. Then press the front part of the
cheek pad in order to hook the snap button located on the back of the cheek pad. (Fig.
8) Repeat steps 2.5 and 2.6 on the right cheek pad.
WARNING!!!
- Take out the inner padding only to clean and wash it.
- Never use your helmet without having correctly and completely replaced the inner
comfort padding as well as the cheek pads.
- Wash gently by hand, with mild soap andlukewarm (max 30°C) water only.
- Rinse in cold water and let dry at room temperature, away from direct sunlight.
- Do not machine wash.
- Inner polystyrene is easily deformed to absorb impact energy bypartial alteration or
destruction.
- Wipe clean with a damp cloth, then let dry at room temperature, away fromdirect sun-
light.
- Never modify the inner components of the helmet polystyrene
- Never use any tools to carry out the above-described operations.
• NFRS – NOLAN FOG RESISTANT SYSTEM
1 INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Make sure that the inner surface of the visor is clean and check that the external
levers for the pin adjustments are turned towards the inside.
1.3 Remove the protective film from the inner visor on the side in contact with the visor.
1.4 Rest one side of the inner visor onto one of the visor pins and hold it in position,
see Fig. 13.
1.5 Widen the visor and fasten the other side of the inner visor to the second pin, see
Fig. 14.
1.6 Release the visor.
1.7 Remove the second protective film from the inner visor and check that the inner visor
profile adheres to the visor.
1.8 Fix the visor onto the helmet.
14