Nolan N100E Seguridad E Instrucciones página 17

2. Take the VPS and verify that the external sliders on both sides are facing forward as in
Fig. 19.
3. Close the helmet chin guard and the visor, then position the VPS as in Fig. 20 ("active
VPS"), making sure that the reference pins "A" on both sides are fit in the proper mech-
anism slots (Fig. 21).
4. Fasten the VPS to the helmet by sliding the side sliders towards the helmet rear part as
in Fig. 22.
Check the VPS correct functioning by carrying out the following steps:
A. Pull up the VPS sunscreen completely by sliding it upwards and skipping the interme-
diate notches.
B. Make sure that in this position ("inactive VPS") - shown in Fig. 23 - the VPS sunscreen
remains steadily open.
C. Pull up the visor and make sure that the VPS sunscreen remains in position until it is
reached by the visor, and that it then slides with the visor until it is fully open.
D. Pull down the visor and check that the VPS sunscreen remains fully open at first and
that it is later pulled downwards to the same intermediate position as at the end of step
A ("inactive VPS"). This way it does not affect visibility.
E. Pull down the VPS sunscreen completely by sliding it downwards, skipping the interme-
diate notches until it overlaps the visor ("active VPS").
While carrying out these procedures, make sure that the VPS mechanism buttons and the
side plates remain still.
In case of malfunctioning, repeat all the above mentioned procedures correctly.
VPS disassembly instructions
To remove the VPS system from the helmet, close the chin guard and the visor. With low-
ered VPS ("active VPS"), slide the VPS sliders forward until they are as in Fig. 20. Detach
the VPS from the helmet by slightly pulling outwards the side ends.
Reassemble the auxiliary side covers on both sides of the visor by inserting the rear flap
into the special mechanism housing. Hook the covers to the mechanism below by press-
ing them onto the front hollow (see Fig. 18). Attention: the right side cover (R) is different
from the left one (L).
Pull the helmet visor up and down to check the correct assembly.
- After each assembly or disassembly procedure of the different parts, always check that
the visor mechanism works properly by pulling the visor up and down; if necessary,
repeat the steps described above.
- If the visor and/or VPS pulling-up /-down mechanisms are damaged or malfunctioning,
refer to a Nolan authorised dealer.
- To disassemble and reassemble the visor, remove the VPS or the auxiliary side covers
as explained before and refer to the proper section in the user's manual.
17