Safety Instructions; Cleaning And Maintenance; Recycling And Disposal; Warranty And Service - Philips 5906131M7 Manual Del Usuario

FAQ
1.Why the downlights do not light up when I press the 'ON/OFF' button?
- Make sure the wall switch has been turned on.
- Check if the AAA batteries inside the remote controller are properly installed.
- The distence between the downlights and the remote controller should be less than 10 meters.
- Make sure that group of downlights is selected by press up the corresponding group control button.
2.Why that is no reaction when I press light color or brightness button?
- Make sure that group of downlights is selected by press up the correct dig group control button.
- When the downlight is in night light mode, the color temperature will no change.
3.Why I can't re-group after ungroup?
- After ungroup, make sure the wall switch turn off and turn on again.
- The downlight should be in default state, i.e. 2700K and 100% brightness.

Safety Instructions

- Do not immerse in water.
- Do not use in wet environment.
- Do not place on hot surface.

Cleaning and maintenance

- To avoid scratching, remote control should only be cleaned with soft dry cloth.
- Do not use strong chemical or cleaning agent as it may damage the plastic parts.

Recycling and disposal

- Please dispose in accordance with instructions from the local authority.
- Remove the batteries when you discard the remote control.
- Do not throw the batteries away with normal household waste.
- Product can be handed in at an official collection point or a Philips dealer for proper disposal.

Warranty and service

If you need service or information or if you have a problem, please visit the Philips website at
www.philips.com/support or contact the Philips Consumer Care Centre in your country. If
there is no Consumer Care Centre in your country, go to your local Philips dealer.
6