Omega OC63TXA Instalación, Uso, Mantenimiento página 93

Placa de coccion vidriocerámico
Tabla de contenido

Publicidad

92
IT
raggiungere una temperatura
superiore di 50 ° C a quella
ambiente.
Desiderando un collega-mento
diretto alla rete, è necessario
interporre un interruttore
onnipolare
con
apertura
minima fra i contatti di 3 mm
dimensionato per il carico di
targa e rispondere alle norme
in vigore (il cavo di terra
giallo/verde non deve essere
interrotto dall'interrut-tore). La
presa o l'interruttore onni-
polare
devono
essere
facilmente raggiungibili con
l'apparecchiatura installata.
N.B.: - Il costruttore declina
ogni responsabilità nel caso
che quanto sopra e le usuali
norme antiinfortunistiche non
vengano rispettate.
Se il cavo di alimentazione è
danneggiato, esso deve essere
sostituito dal costruttore o dal suo
servizio assistenza tecnica o
comunque da una persona con
qualifica similare, in modo da
prevenire ogni rischio.
GB
Should a direct connection to the
network be required, it will be
necessary to interpose an om-
nipolar switch with minimum
aperture between the 3 mm. con-
tacts, dimensioned to bear the
plate load and it must follow the
standards in force (the yellow/
green earth cable must not be
interrupted by the switch). The
plug or omnipolar switch must
be easily reached on the installed
equipment.
The manufacturers decline any
responsibility in the event of
non-compliance with what is de-
scribed above and the accident
prevention norms not being re-
spected and followed.
To avoid all risk, if the
power
cable becomes
damaged, it must only be
replaced
by
the
manufacturer,
by
authorised service centre,
or by a qualified electrician.
FR
50 ° C à celle ambiante.
Si on désire une connexion
directe au réseau, il faut
prévoir un dispositif de
coupure omnipolaire avec
une distance d'ouverture
entre les contacts de 3 mm
dimensionné à la puissance
de plaque et qui suit les
normes en vigueur (le fil de
terre de couleur jaune/vert
ne doit pas être coupé par
l'interrupteur). La prise ou
l'interrupteur omnipolaire
doivent être facilement
accessibles après la mise en
place de l'appareil.
Le Constructeur décline
toute responsabilité au cas
où ces normes et les autre
normes contre les accidents
ne seraient pas observées.
Si le câble d'alimentation est
endommagé, le constructeur,
le
service
d'assistance
technique ou un technicien
an
qualifié devra le remplacer
afin d'éviter toute sorte de
risque.

Publicidad

Tabla de contenido
loading

Tabla de contenido