NORAUTO NO6704 Instrucciones De Uso página 79

battery is over 3 bars, wait 3 minutes to try again.
7. After the engine is successfully started, first pull the "smart clamps" off
the device and then remove the clamps from the car battery.
8. Charge the unit immediately after each use.
SMART CLAMPS
GREEN RED
SN
LED LED
1 Flash Flash
2 On Off
3 Off On
4 Off On
5 Off On
6 Off On
7 Off On
USB OUTPUT
1. Connect the USB cable to the USB output port of the device (3), 5V DC,
2.4A or 9V DC , 2A, please refer to the technical data.
2. Short press the "POWER" button (5), USB provides 5V 2.4A output
to provide charging for mobile phones/tablets and other electronic
products.
3. The USB output will be automatically turned off after charging is
completed.
4. When the load current exceeds 2.4A, the USB output will be automatically
turned off.
AUDIBLE
WARNING
Off No car battery connected.
Off Connected to the standby state.
On Short circuit alarm.
On Reverse polarity alarm.
Reverse charging voltage protection.
On
Internal temperature exceeds 75 °C,
On
over temperature alarm.
Time-out alarm (connection status
Off
exceeds 30s).
STATUS
EN
78