Spark Plug Service
WARNING
Hot engine components can cause severe
burns.
Stop engine and allow it to cool before check-
ing spark plugs.
Clean or replace the spark plugs and reset spark
plug gap (A) every 100 hours of operation.
•
Disconnect the spark plug caps from the spark
plugs and remove the spark plugs.
Clean the electrodes (B) by scraping with a wire
brush to remove carbon deposits.
Inspect for cracked porcelain or other wear and
damage. Replace the spark plug with a new one
if necessary.
Check the spark plug gap and reset if necessary.
The gap must be 0.75 mm (0.030 in). To change
the gap, bend only the side–electrode, using a
spark plug tool.
Install and tighten the spark plugs to 22 N·m (2.2
kgf·m, 16 ft·lb). Connect the spark plug caps.
RECOMMENDED SPARK PLUG
NGK ..................................BPR4ES
A. Spark Plug Gap
B. Electrodes
29
27
MAINTENANCE
MAINTENANCE