6600
INSTALLATION OF TYPE 6600/AU WITH BRACKETS TYPE R660
- Make a 120x120mm (nearly) hole in the plasterboard wall
- Fix the brackets type R660 to the phone 6600/AU
- Fix the bracket to the phone as indicated in figure, keeping the cursors
well aligned to the phone sides.
- Insert the phone inside the wall in plasterboard.
- Tighten the screws so as the cursors can get closer to the plasterboard
Citofono serie 6600/AU
Citofono serie 6600/AU
wall.
Installazione su parete
Installazione su parete
- By screwing, the cursors should get aligned orthogonally to the phone.
- Insert the side grids, paying attention that the one with the slot for the
tipo cartongesso
tipo cartongesso
microphone must be inserted on the right.
Fig. 2A
INTSLLATION OF TYPE 660C
- Fix the phone support to the wall and hook the stud to the support.
Table version
139
mm
40mm
EN
125mm
141mm
Fig. 2C
INSTALLATION OF TYPE 6700/AU
- Fix the phone fixing plate at 1,40m. from the ground level to the lower
border.
- Connect the terminal block.
- Insert the phone according to the 1 and 2 arrow direction
- To remove the phone from the plate hook, operate with a screw driver on
the security lock, and remove it according to the 3 and 4 arrow direction.
Surface wall-mounting
139
136
mm
141 mm
59mm
10mm
Fig. 2B
INSTALLATION RULES.
125
Installation should be carried out observing current installation regulations for
mm
electrical systems in the Country where the products are installed.
CONFORMITY.
EMC directive
Standards EN 61000-6-1, EN 61000-6-3.
INFORMATION FOR USERS UNDER DIRECTIVE 2002/96 (WEEE)
In order to avoid damage to the environment and human health as
well as any administrative sanctions, any appliance marked with this
symbol must be disposed of separately from municipal waste, that
is it must be reconsigned to the dealer upon purchase of a new one. Appli-
ances marked with the crossed out wheelie bin symbol must be collected in
accordance with the instructions issued by the local authorities responsible
for waste disposal.
version
141mm
1
3
2
139
mm
40mm
4
5