Electrolux EFG60750 Manual Del Usario página 10

10 electrolux
DRILLINg ThE SUPPoRT SUR-
faCE aND fITTINg ThE hooD
• The Hood can be installed directly on
the underside of wall-mounted units
(650 mm min. from the Cooker Top)
EN
using the snap-on side supports and
screws provided.
• Create an opening in the bottom
of the wall mounted unit, as shown
(fig.1), leaving a distance of at least
20mm from the front.
• Fit the two hood support brackets
(fig.2) using the screws 12a (3.5 x 16)
at a distance B of min. 85mm - max.
165mm. The brackets must be fitted
differently according to the size of the
hood to be mounted.
• Remove the Comfort Panel (see the
paragraph on Maintenance).
• Remove the metal grease filters one
at a time, releasing the fasteners pro-
vided (see the paragraph on Mainte-
nance).
• Remove the profile after unfastening
the 4 screws that fix it to the Hood
(fig.4).
• Remove any Activated Charcoal
Filters (see the paragraph on Mainte-
nance).
• Insert the Hood until it connects with
the snap-on side Supports. (fig.3)
• Lock it in position by tightening
screws vf from underneath the
Hood. (fig.3)
• It is now possible to fasten the hood
to the wall-mounted unit using the
screws 12a (3.5 x 16) provided.
(fig.4).
• Replace the profile, using the 4
screws removed as above.
• Replace the filters.
• Replace the Comfort Panel.
Installation
���
2
3
��
���
1
�
4