Steren AMP-200 Manual De Instrucciones página 19

1.- Input level control: Allow one to control the volume level from the audio sources connected to
Input 1, Input 2, Input 3, Input 4 and Auxiliary input, individually.
2.- Bass control: This control enhances or attenuates the low frequency reproduction.
3.- Treble control: This control enhances or attenuates the high frequency reproduction.
4.- Main volume control: Set the general volume level
5.- Indicator: When switching the amplifier's power on, the PL indicator lights. When the amplifier's
output overload, the OVERLOAD indicator lights and interrupt signal output. For a better output set
the volume level at the middle of the scale.
6.- VU-meter: The instrument shows the signal's output level. The first eight LEDsegments on the
down, represent the area between -20dB and 0dB, keep the signal in this area. If the superior LEDs
are lit, then represent an audio signal distortion. Set the volume level to get a clear sound.
7.- On / Off
8.- Main cord connector: Allow one to plug the supplied power cord.
9.- Output connectors for auxiliary speakers:
This terminal is meant for the connection of a
small speakers that gets driven by an internal
auxiliary power amplifier, providing a nominal
output of 1W. Only the mixed audio signal
coming from.
AUX IN are included in the outputted signal. The
output signal is controlled only by the volume control
of the AUX IN.
6