SANUS VuePoint F180d Manual De Instrucciones página 13

3. Drill pilot holes using a 7/32 in. (5.5 mm) diameter drill bit. Remove wall plate template
IMPORTANT: Be sure to drill into the center of the stud.
IMPORTANT: Pilot holes must be drilled to a depth of 3 in. (75 mm).
4. Install wall plate using washers
16
the wall plate .
16
CAUTION:
Avoid potential personal injury or property damage! All four lag bolts
movement of the wall plate
3
and lag bolts
18
17
. Ensure the wall plate is securely fastened to the wall before continuing on to the next step
16
3 in. (75 mm)
7/32 in.
(5.5 mm)
15
15
. Tighten the lag bolts only until the washers
18
18
4
.
are pulled firmly against
17
MUST BE firmly tightened to prevent unwanted
16
18
17
13