Bestway FLOWCLEAR 58404 El Manual Del Propietario página 5

Assembly
(You will need a screwdriver.)
1. Carefully remove all components from the package and check to ensure nothing
is damaged. If equipment is damaged,immediately notify the retailer from where
the equipment was purchased.
2. The sand filter should be placed on solid, level ground, preferably a concrete
slab. Position the sand filter so the Ports and Control Valve are accessible for
operation, servicing and winterizing.
3. EN60335-2-41 TEST standard requires the sand filter to be vertically fixed on
ground or a certain pedestal made of wood or concrete before use to prevent the
sand filter from accideutally falling. Fully assembled sand filter will exceed 18kg. The mounting holes should be 8mm
in diameter and spaced 110mm apart. Use two bolts and nuts with a maximum of 8mm in diameter to fasten the sand
filter to the pedestal.
Load pool-grade filter sand.
NOTE: Use only special pool-grade filter sand, free of all limestone or clay: #20 Silica sand
0.45-0.85mm, approximately one 25kg bag should suffice. If you do not use the recommended size
filter sand, filtering performance will be reduced and the sand filter may damaged, thereby voiding
warranty.
NOTE: To avoid damaging the Skimmer when adding sand, pour some water into the Bottom Tank
to submerse the Skimmer on the Collector Hub.
NOTE: SAND NOT INCLUDED.
Connect to the pool
1
S-S-005009/21.0x28.5cm/58404EU / 1500gal 欧规砂滤器说明书/JS-YF-2016-B-08878-英
C
C
A
B
A
A
B B
MAX
MIN
C
C
A
B
5
110mm
Ø8mm
S-S-005009