Diagram Of Freezer; Temperature Display - Maxx Cold MXDC-4 Manual De Operación, Instalación Y Mantenimiento

food (ice cream tubs, etc.) and the environmental temperature/required conditions for the stored product to
maintain its quality.
6. Before putting product into the freezer please adjust the temperature control to its lowest set point and let it run
until the temperature of inner cabinet decreases to 0°F (-18°C.) Once the unit reaches 0°F (-18°C), set the unit to
your devised set point and load product. NOTE: For high elevation installations, it may be necessary to "warm-
up" the cabinet to higher set points.
7. Unplug the appliance by pulling the cord cap (plug) NOT the electrical cord.
8. Never put hot food in the freezer. Only place product in the freezer after it is has reached its ideal storage
temperature. Some foods will need to be placed in a refrigerator or another freezer to cool down past room
temperature prior to placing in the freezer.
9. Do not overfill the unit. Keep the top item at least 4" (10cm) below the brim on the cover. There should be
reasonable space between the food items for better temperature regulation.
10. If a power outage occurs, you should wait at least 5 minutes before the freezer is turned on again to avoid damage
to the compressor.
11. Never store any flammable, explosive and corrosive liquid or gas in the freezer. Keep it away from this appliance.
12. Beer, beverage, fresh flowers, medicine and injections cannot be put into the freezer for storage or cooling.
Handling them in the freezer voids the warranty
13. If the stored items are not place in properly sealed, protective packaging, then ice crystals may form or the
product quality can be affected.
NOTE! Before loading product we recommend you run the unit empty for two to three days. This allows you to be
sure electrical wiring and installation are correct and no shipping damage has occurred.
LOSS of FOOD PRODUCT IS NOT COVERED BY THE WARRANTY!

DIAGRAM of FREEZER:

1. Upper Sliding Lid
2. Lock and key
3. Lower Sliding Lid
4. Cabinet Body
5. Compressor Cover
(Louvered for Air Flow)
6. Power indicator
7. Thermostat
8. Power Cord and Plug
9. Thermometer
10. Caster

TEMPERATURE DISPLAY:

The thermometer shows the warmest frozen food temperature. It is adjusted and designed so that only temperature
below 32°F (0°C) is accurately displayed.
4