Technical Specifications; Disposal Of Old Electrical Appliances - cecotec CONGA 1790 VITAL Manual De Instrucciones

ENGLISH
02 4
Other possible situations
Problem
The robot cannot be activated
The robot stops operating suddenly
The schedule function does not work
Weak suction power
The robot does not charge
46
Main brush error Check if the main
brush is entangled or
blocked and clean it.
Solution
Make sure the main power switch is in the ON
position.
Make sure the battery is fully charged.
If the problem persists, turn the main power
switch off and restart it.
Check if robot is trapped or stuck on an
obstacle.
Check if the battery level is too low.
If the problem persists, turn the main power
switch off, wait for 2 seconds and restart it.
Make sure the main power switch on the
bottom of robot is turned on.
Make sure the time, time of day (AM/PM), and
the scheduled time have
been set correctly.
Check if robot's battery is too low to start
cleaning.
Check if any obstructions are blocking the
suction inlet.
Empty the dust in the tank.
Clean the filters with a vacuum cleaner or a
cleaning brush.
Check if the filters are wet.
Air-dry the filters completely before use.
Check if the indicator on the charging base
are lighted up. If not, contact the Technical
Support Service of Cecotec.
Clean the charging terminals with a dry cloth.
Check if the robot beeps when it gets to the
charging base. If not, contact the Technical
Support Service of Cecotec.
The robot does not return to the charging
base
The main brush does not rotate
The robot movements and routes are
usual.

6. TECHNICAL SPECIFICATIONS

Product: Conga 1790 Vital
Product reference: 05471
Output voltage: 19 V DC
Output current: 0.6 A
Power: 40 W
Battery: 14.4 V DC Li-Ion 2600 mAh
100-240 V AC ~, 50/60 Hz
Made in China | Designed in Spain

7. DISPOSAL OF OLD ELECTRICAL APPLIANCES

The European directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE), specifies that old household electrical appliances must
not be disposed of with the normal unsorted municipal waste. Old appliances
must be collected separately, in order to optimize the recovery and recycling
of the materials they contain and reduce the impact on human health and
the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation to
dispose of the appliance correctly. Consumers must contact their local authorities or retailer
for information concerning the correct disposal of old appliances and/or their batteries.
ENGLISH
Remove objects within 3 ft/1 m to the left and
right side and within 6 ft/2 m of the front of
the charging base.
The robot will return quicker to the charging
base when it is close to it. If the robot is far
away from it, it will take longer to detect it.
Clean the charging terminals.
Clean the main brush.
Check if the main brush is properly installed.
Clean the sensors carefully with a dry cloth.
Restart the robot by turning the power switch
off and on.
47