General Notes; Area Of Application; Gb - Operating Manual - Titan Pump-Runner 650e Manual De Instrucciones

Pump-Runner

General notes

Before using this accessory for the fi rst time read through
these Operating Instructions and also familiarise yourself
with the Operating Instructions for the paint spraying
unit. The safety instructions for the paint spraying unit
apply to this accessory.
Before operation or transport check the
state of the seals and catches and replace
if necessary.

Area of application

The cleaning of a Titan spray unit can be made easier with the
Pump-Runner. For this the Pump-Runner is fi lled with a suit-
able cleaning fl uid, which is circulated by the pump unit.
This prevents the valves from drying out and sticking during
short interruptions to work.
The use of the Pump-Runner can prevent the intake system
from drying out and a change of location can take place with-
out contaminating the workplace.
The Pump-Runner is suitable for the following Titan models
with a rigid intake system (Status July 2009):
Piston pumps
650e 640i
750e 740i
850e 840i
1150e 1140i
For use with diff erent Titan units, diff erent sealing rings must
be used in the lid.
The seals required for the particular unit are:
Model designation
650e, 640i, 740i
750e
850e, 1150e, 840i,1140i
The Pump-Runner is not suitable for fl exible intake systems.
Scope of supply (Fig. 1)
•
•
•
•
•
•
* If the Pump-Runner is included with the basic unit, only the
necessary sealing ring is included in the delivery.
Assembly (Fig. 2 and 3)
1)
2)
Marking on
3)
sealing ring
4)
ø 1.3"
750e, EPX2355
5)
ø 2.2"
6)
7) Attention! Sealing ring must be greased.
8)
9)
10)
Reservoir (1)
Lid (2) with openings for intake pipe (3) and return hose
(4)
Hose clip (5)
Sealing ring set for intake pipe (6)*
Lubricating grease
Operating Instructions
1
2
3
Mount the intake system onto the paint spraying unit
as described in the Operating Instructions for the paint
spraying unit.
Put piston pumps in the horizontal position
for easier fi tting.
Push the lid (1) over the intake pipe from below.
Grease the outside of the sealing ring (2) with lubricating
grease provided.
Push the sealing ring (2) onto the intake pipe (3) with the
lip downwards.
For PS30 and PS34 refi t the inlet valve housing on the intake
system.
Position sealing ring (2) as shown in Fig. 2.
Push the lid (1) onto the sealing ring (2) from above up to
the stop.
Slip on the hose clip (4) from below and tighten with an
open-ended spanner (Size 10), until the lid can no longer
be moved by hand.
Pull the return hose (5) through the smaller opening in the
lid.
Insert the Pump-Runner reservoir from below and secure
on the lid with the two catches (6).
4
5
6
GB
5