MOLINO move ELECTRIC STEP Instrucciones De Uso página 6

HANDLEBARS
EN
Insert grips into handlebar T-Frame as shown in fi g. 3. Be sure that snap pins fi t
into, and lock, the small holes located at the top of the T-Frame. With the hand-
lebars in the upright and locked position, and the rider standing on the platform
with ONE FOOT on the brake, adjust the handlebar height to just below the rider's
waistline. This is accomplished by loosening the height adjuster (fi g. 3) while
holding and tightening height adjuster. Be sure height adjuster is tight again.
POWER SWITCH
The scooter is equipped with a power switch located towards the front of the
scooter platform (fi g. 1).When depressed, the power is on, and the motor and
rear wheels cause the scooter to move forward.
HAND OPERATED ACCELERATION
This scooter is equipped with a hand-operated accelerator located on the right
hand side of the handlebars. Use four fi ngers to depress or release, with the
other fi ngers placed on the side of the handlebar, control the magnitude of the
acceleration.
HAND OPERATED MECHANICAL BRAKE
The rear wheel brake is engaged by depressing the brake lever located on the left
hand side of the handlebar. This can be performed by using four fi ngers of the
left hand, with the thumb placed on the handlebar itself. This is a friction brake.
The harder it is pressed, the more "braking" action will be applied on the rear
wheel. This brake has a micro device that will deactivate the power of the motor
simultaneously.
RANGE AND SPEED
When fully charged the scooter will cover approximately 15km on level ground,
with a 70 kg rider. The top speed is approximately 15km/h with a 70kg rider on
level ground and calm winds. Please note that these fi gures are estimates only,
thus they may vary.
STEERING ADJUSTMENT NUTS
You will need to periodically check the steering for looseness. The tightness of
the steering can be adjusted by turning the round nut clockwise and locking the
hex nut (fi g. 1).
CHARGING
When shipped, the batteries are fully charged. Charging the batteries after every
use is recommended. For extended battery life, avoid discharging batteries
6
2020-08-13 OCG Molino E-step ManualV01.indd 6 2020-08-13 OCG Molino E-step ManualV01.indd 6 28-08-20 16:24 28-08-20 16:24