MOLINO move ELECTRIC STEP Instrucciones De Uso página 8

REMOVABLE PLATFORM
EN
The platform is removable to gain access to the batteries. Simply remove the
four deck screws with a Phillips screwdriver (fi g. 5), and lift off the platform.
Reverse procedure to replace platform.
USE A PHILLIPS SCREWDRIVER TO REMOVE PLATFORM
CAREFULLY REMOVE SCREWS, SPRING AND BRAKE PEDAL TO GAIN BATTERY
ACCESS.
DRIVE BELT ADJUSTMENT AND REPLACEMENT
Periodic adjustment of the drive belt is highly required. The belt will become
loose after hours of operation. Thus, when this happens, the belt will make a
popping sound while accelerating. When this occurs, you must tighten the drive
belt immediately. To tighten the belt, slightly loosen near rear axle nuts and
rotate the belt adjuster discs equally (fi g. 6). Tighten axle nuts and recheck belt
tension.
8
2020-08-13 OCG Molino E-step ManualV01.indd 8 2020-08-13 OCG Molino E-step ManualV01.indd 8
Fig. 5
Fig. 6
28-08-20 16:24 28-08-20 16:24