MOLINO move ELECTRIC STEP Instrucciones De Uso página 9

DRIVE BELT ALIGNMENT
If you experience either the drive belt coming off the drive gear or the wheel
gear and/or rubbing against the scooter frame, there most likely is belt misalig-
nment. To re-align, carefully place the scooter upside down on a sturdy surface
(table, stool, etc.) and determine the direction of the belt-side movement (fi g. 7).
You will slightly need to move the rear wheel left or right to re-align. To do this,
slightly loosen axle nuts and rotate the belt adjuster discs. Tighten axle nuts and
check alignment by engaging power. Recheck alignment after riding; readjust if
necessary.
*Installation of Seat (For models with seats only)
Important:
Press down the seat column into the hole on the main board. Ensure the snap
pin pops out and lock the piece properly, and clip fi rmly. Insert the seat into the
upper hole, use a spanner to tighten the locking net, ensure the seat is stable to
use. The seat can only be used with this product when the steering is completely
locked. This must be checked by an adult prior to use.
2020-08-13 OCG Molino E-step ManualV01.indd 9 2020-08-13 OCG Molino E-step ManualV01.indd 9
Fig. 7
EN
9
28-08-20 16:24 28-08-20 16:24