In Order To Ensure That Your Shaver Works Perfectly, Please Observe The Following; Before First Use; Operating The Shaver Using The Ac Adaptor Plug; Charging The Rechargeable Batteries - Silvercrest SFR 1200 A1 Instrucciones De Utilización Y De Seguridad

Safety / Before first use
In order to ensure that
your shaver works
perfectly, please observe
the following
N ever expose your shaver to temperatures below
0 °C or above +40 °C. Do not place the shaver
down on radiators or fan heaters.
A lways make sure that the flex does not get
jammed in cupboard doors or is pulled over
hot surfaces.
D o not use a screwdriver or pliers to change
the cutter set . This will damage the shaving
12
foil .
4
P lease use only the original AC adaptor plug
supplied with your shaver for mains operation.
Insert the plug only into a socket within easy
reach. In order to avoid inadmissible overheating,
do not cover the AC adaptor plug.
Please check the AC adaptor plug and shaver
for any mechanical faults at regular intervals.
Replace faulty parts with an original part if
possible (see your specialist dealer). Never try
to repair a faulty appliance yourself! Repairs
should only be carried out by a specialist
dealer or by our service centre (see section
"Warranty and service").
Used or defective rechargeable bat-
teries must not be disposed of with
the usual domestic waste! Always
take your used rechargeable batteries to the
designated collection point (see section on
"Disposal").

Before first use

CAUTION! Oil residue on the shaving foil.
Due to the manufacturing process, you may find
some oil residue still on the shaving foil when
you unpack the razor. Remove the oil with an
absorbent, lint-free cloth before starting the
device for the first time.
38 GB/MT
The shaver can be used as a battery-operated or
mains-operated device.
Operating the shaver using the
AC adaptor plug
CAUTION! RISK Of ELECTRIC SHOCK!
Never touch the device with wet hands when it
is connected to the mains supply.
F irst insert the connection lead of the plug-in
mains adapter into the input socket for the
plug-in mains adapter
the device and insert the plug-in mains adapter
into the mains socket. The device is ready for
immediate use.
Charging the rechargeable
batteries
The shaver has two high-capacity Ni-MH recharge-
able batteries with overcharge protection. The
batteries can be recharged without undergoing
a reduction in performance. There is no risk of over-
charging them.
Note: Allowing the rechargeable batteries to be
completely discharged before recharging them will
increase their overall service life. To completely
discharge the batteries, run the device until the
charge reduces to 20 % and the LED starts to flash
red (indicating that a recharge is necessary).
The rechargeable battery in the shaver should be
charged for at least 120 minutes before the shaver
is used for the first time. For subsequent recharging
processes, a charging time of about 90 minutes is
adequate. Proceed as follows to charge the batteries:
S witch off the device. Slide the ON / OFF
switch downwards.
7
C onnect the connection lead of the plug-in mains
adapter to the input socket for the plug-in mains
adapter on the shaver. The device begins
11
the charging process.
on the underside of
11