Cleaning The Tank; Troubleshooting - ARIETE Cafe Roma Plus Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
Warning!
Do not wash pod filter in a dishwasher.
cleaning the Maxi cappuccino device
Warning!
Perform this operation when the chrome-plated pipe is cold so as to prevent burns.
Unscrew the device (O) from the small pipe and wash it with running water. The small pipe can be cleaned with a non-abra-
sive cloth. Screw the cappuccino maker back on as far as it will go. If necessary, clean the small steam outlet hole again with
a pin. After use, always let the steam nozzle run for a few seconds so to free the outlet from any possible residue.
cleaning the grill and water recovery drawers
remember to empty the water recovery drawers (Q) and (r) from time to time.
Remove the two drawers from the machine, empty them and wash them under running water. Also wash the cup grill (S).
cleaning the machine body
Warning!
Clean the fixed parts of the machine using only a damp, non-abrasive cloth so as to not damage the body.

cleaning the tank

Periodically clean the inside of the tank with a sponge or damp cloth.
DecAlcIFIcATIOn
Good maintenance and regular cleaning preserve and keep the machine efficient for a longer amount of time, considerably
limiting the risks of lime deposits forming inside the appliance. However, should your coffee machine fail to work properly
as a result of the frequent use of hard, high calcium content water, you may perform a decalcification procedure to restore
its operational efficiency. For this purpose you must use only Ariete's, citric acid-based decalcifying products (NOCAL). This
product is easily found at the Ariete technical service centres. Ariete does not assume any responsibility whatsoever for
damage to components inside the coffee machine caused by the use of non-compliant products containing chemical addi-
tives. Should you need to decalcify your appliance, please follow the instructions which come with the decalcifying product.
puTTInG OuT OF serVIce
If you want to put the machine out of service, you must disconnect it electrically, empty the water tank and drip tray and clean
it (see the paragraph on "Cleaning the appliance").
In the case of scrapping, you must separate the various materials used in making the machine and dispose of them based
on their composition and on the legal provisions in force in the country of use.

TrOuBleshOOTInG

Warning!
If there are problems with operation, immediately turn off the machine and unplug it from the socket-outlet.
proBLem
Cause
the coffee maker
Air has probably entered the cir-
does not supply
cuit and deactivated the pump.
boiling water for
tisanes.
The steam exit hole on the dis-
penser wand is clogged.
the coffee maker
There is little water and the pump
does not supply
does not suck it up.
steam.
The steam exit hole on the dis-
penser wand is clogged.
steam overflow-
You are trying to dispense the
ing from the
coffee with the steam function
edges of the filter
on. Check that the steam
ring.
function button has not been
unintentionally pressed.
soLutions
Make sure the tank is properly inserted and that the water is not
below the minimum level. Repeat the operations described in
the "Preliminary phases for use" paragraph.
Unclog any deposits that may have formed in the hole of the
dispenser wand with a pin.
Check that the water level in the tank is correct. If necessary, fill
it with cool tap water.
Unclog any deposits that may have formed in the hole of the
dispenser wand with a pin.
Stop dispensing the coffee. Press button (7) to turn off the
steam function. Wait for the indicator lamp (2) to change from
blinking to steady before preparing new coffee.
17

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

1329/1

Tabla de contenido