Kenmore 795.5183 Manual De Uso Y Cuidado página 13

Removing the right (refrigerator) door
wire
harness
1. Open the door. Remove the top hinge cover screw.
2. Use a p at blade screwdriver to pry back the hooks
(not shown) of the hinge cover from the top of the
refrigerator cabinet. Lift up the cover. Disconnect all
wire harnesses.
upper
hinge
3. Rotate the hinge lever clockwise (1). Lift the top hinge
free of the hinge lever latch (2).
CAUTION: When lifting the hinge free of the latch,
be careful that the door does not fall forward.
4. Lift the door from the lower hinge pin.
lower hinge
5. Place the door, inside facing up, on a non-scratching
surface.
Reinstalling the right (refrigerator) door
1. Place the door onto the lower hinge pin.
2. Fit the upper hinge over the hinge lever latch and
into place. Rotate the lever counterclockwise to
secure the hinge.
3. Reconnect all wire harnesses. Hook the tab on the
switch side of the cover under the edge of the wire
opening in the cabinet top. Position the cover into
place. Insert and tighten the cover screw.
hinge lever
Reinstalling the left (freezer) door
1. Feed the water tubes through the lower hinge pin
and place the door onto the lower hinge pin. Water
hoses should be behind the leg to prevent damage.
2. Fit top hinge over the hinge lever latch and into
place. Rotate the lever clockwise to secure the hinge.
3. Connect all the wire harnesses.
4. Hook the tab on the door switch side of the cover
under the edge of the wire opening in the cabinet
top. Position the cover into place. Insert and tighten
the cover screw.
5. Reconnect the water tubes by inserting the tubes into
the connectors. The tube is inserted correctly when
only one guide line is showing out of two.
Collet
Tube
Insert Line
13
REFRIGERATOR INSTALLATION