Kenmore 795.5183 Manual De Uso Y Cuidado página 39

Problem
Ice has bad taste or
odor.
Dispensing warm
water.
Water has bad taste
or odor.
Icemaker is making
too much ice.
Possible Causes
Water supply contains minerals such
as sulfur.
Icemaker was recently installed.
Ice has been stored for too long.
The food has not been stored
properly in either compartment.
The interior of the refrigerator needs
to be cleaned.
The ice storage bin needs to be
cleaned.
Refrigerator was recently installed.
The water dispenser has been used
recently and the storage tank was
exhausted.
Dispenser has not been used for
several hours.
Refrigerator is connected to the hot
water supply.
Water supply contains minerals such
as sulfur.
Water o lter has been exhausted.
Refrigerator was recently installed.
Icemaker shutoç (arm/sensor) is
obstructed.
A water o lter may need to be installed to eliminate
taste and odor problems.
NOTE: In some cases, a o lter may not help. It may not
be possible to remove all minerals / odor / taste in all
water supplies.
Discard the o rst few batches of ice to avoid discolored
or bad tasting ice.
Ice that has been stored for too long will shrink,
become cloudy, and may develop a stale taste. Throw
away old ice and make a new supply.
Rewrap the food. Odors may migrate to the ice if
food is not wrapped properly.
See the Care and Cleaning section for more
information.
Empty and wash the bin (discard old cubes). Make
sure that the bin is completely dry before reinstalling
it.
Allow 24 hours after installation for the water storage
tank to cool completely.
Depending on your specio c model, the water storage
capacity will range from approximately 20 to 30 oz
(0.6 - 0.9 liter).
If the dispenser has not been used for several hours,
the o rst glass dispensed may be warm. Discard the
o rst 10 oz (0.3 liter).
Make sure that the refrigerator is connected to a cold
water pipe.
WARNING: Connecting the refrigerator to a hot
water line may damage the icemaker.
A water o lter may need to be installed to eliminate
taste and odor problems.
It is recommended that you replace the water o lter:
• Approximately every 6 months.
• When the water o lter indicator turns on.
• When the water dispenser output decreases.
• When the ice cubes are smaller than normal.
Dispense 2.5 gallons (9.5 l) of water (p ush for
approximately 5 minutes) to remove trapped air and
contaminants from the system. Do not dispense the
entire 2.5 gallon (9.5 l) amount continuously. Depress
and release the dispenser pad for cycles of 30
seconds ON and 60 seconds OFF.
Empty the ice bin. If your icemaker is equipped with
an ice shutoç arm, make sure that the arm moves
freely. If your icemaker is equipped with the electronic
ice shutoç sensor, make sure that there is a clear path
between the two sensors. Reinstall the ice bin and wait
24 hours to cono rm proper operation.
39
TROUBLESHOOTING GUIDE
ICE & WATER
Solutions